Additional vertical and horizontal brackets are available for the DA2 allowing for more hardware or complex components to be installed in the case. The brackets are supplied as a set...
With the introduction of the tempered glass side panels, adequately cooling high-performance components in the DA2 can become a challenge if not properly considered as airflow from the side panels...
The Streacom HT4 thermal riser has been designed to be used in conjunction with our FC series cases in order to expand motherboard compatibility by raising the heat pipes above...
There have been a few CPU cooler mounting hole changes over the years and we have released various brackets to accommodate for those such as the AM1 or AM4. In...
The LH6 Kit for DB4 was designed to expand the CPU cooling from a single side panel to two side panels. It comprises of heat pipes, heak sink connectors, universal...
The USB E2C cable is designed as a direct replacement for the existing USB Type-C 3.0 19Pin cable pre-installed in the case, bringing support for newer motherboards that feature USB3.1...
The GPU cooling kit was designed to bring silent performance/gaming to the DB4 by allowing a discreet graphics card to be passively cooled using one of the side panels. It...
Designed to replace the stock heat pipes supplied with FC5, FC9 and FC10 Chassis, the LH4 kit contains a full set of extended length heat pipes which gives an additional...
Whilst our design language leans towards understated system builds, glass is a beautiful material and we do concede that some hardware should definitely be put on display, so here it...
Designed to replace the stock heat pipes supplied with the FC8 Evo, the MH1 kit contains a full set of mini heat pipes. These shorter heat pipes have been specifically...
USB Type-C 3.0 19Pin cable compatible with our Type-C front I/O module
USB Type-C may be the future port of choice for all devices, but not everyone or every device is using it yet. With that in mind and to allow for...
You've viewed 12 of 19 products