DA2 PSU and Drive brackets allow more drives or a redundant PSU to be fitted inside the case. Both must be used in conjunction with the vertical/horizontal universal brackets for...

CPU Mount assembly for fanless cases, F-Type design, support for 4 'FLAT' heat pipes as used with FC5, FC8, FC9 and FC10 cases. Can be purchase as the full assembly,...

The DX2 I/O module is designed to be compatible with 'D' series cases (ex. DB4) and provides an alternative or additional range of ports for your PC. Available in a...

Used to secure the heat pipes to the case heat sink, compatible with current generation FC5, FC8, FC9 and FC10 cases that use the 'flat' type heat pipes. Set of...

Original DA2 Dust Nets for both the side and upper/lower panels. The side nets are available in either the original magnetic design (V1) or the revised clip design found on...

Hex Standoff, typically used to secure motherboard or other PCBs, available in different lengths, M3 thread, in packs of 10pcs

Replacement EPDM Pads used on the DA2 side panel to secure them to the frame, supplied in a pack of 4pcs

The USB C2E cable is designed as a direct replacement for the existing USB Type-C 3.0 19Pin cable pre-installed in the case, bringing support for newer motherboards that feature USB3.1...

With a volume of just 6ℓ but with a maximum TDP of 95W* the FC8 is a marvel of both thermal performance and minimalist design.The small, sleek all-aluminium construction features...

CPU Mount assembly for fanless cases (D series cases), two-part design with copper shim and AL block to support 6 x 6mm heat pipes

The DA2 upgrade kit is designed to allow customers that own the original version of the case to add the key feature improvements of the V2 to their model. This...

Compatible with all our cases, front power switch and LED cable, available in different lengths.